Home > Reference Library

• ELEMENTS OF METRIC GEAR TECHNOLOGY
    Table of Contents
  1. Introduction to Metric Gears
  2. Introduction to Gear Technology
  3. Details of Involute Gearing
  4. Spur Gear Calculations
  5. Internal Gears
  6. Helical Gears
  7. Screw Gear or Crossed Helical Gear Meshes
  8. Bevel Gearing
  9. Worm Mesh
10. Tooth Thickness
11. Contact Ratio
12. Gear Tooth Modifications
13. Gear Trains
14. Backlash
15. Gear Accuracy
16. Gear Forces
17. Strength & Durability of Gears
18. Design of Plastic Gears
19. Features of Tooth Surface Contact
20. Lubrication of Gears
21. Gear Noise
22. References & Literature of General Interest

• HANDBOOK OF TIMING BELTS & PULLEYS
  1. Introduction
  2. Comparative Graphs
  3. Drive Comparative Graphs
  4. Belt Configurations & Construction
  5. Belt Tooth Profiles
  6. Pulley Pitch and Outside Diameters
  7. Design & Installation Suggestions
  8. Belt Tensioning & Alignment
  9. Idler Usage
10. Belt Pull & Bearing Loads
11. Standards Applicable to Belts
12. Standards Applicable to Pulleys & Flanges
13. Double-Sided Twin Power® Belt Tolerance
14. Long Length Timing Belt Stock Specifications
15. Design Aids on Internet | www.sdp-si.com
16. Drive Ratio Tables
17. Center Distance Formulas

• Synchronous Belt Failure Analysis Guide:
  Provided by Gates®: >> Download

• Design & Application of Small Standardized
  Components: >> Couplings & Universal Joints

• Power Transmission Engineering Article:
  >> Criteria for Power Transmission Couplings

• ESCAP® Ironless Rotor D.C. Micromotors
  and Step Motors:
  >> Data Book Section Four Motors